|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
DDU7C 10-TAP, TTL-INTERFACED FIXED DELAY LINE (SERIES DDU7C) FEATURES * * * * * * Ten equally spaced outputs Fits standard 16-pin DIP socket Low profile Auto-insertable Input & outputs fully CMOS interfaced & buffered 10 T2L fan-out capability IN T2 T4 T6 T8 T10 N/C GND 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 T1 T3 T5 T7 T9 data 3 (R) delay devices, inc. PACKAGES VDD IN N/C T2 T4 T6 T8 GND 1 2 3 4 5 6 7 14 13 12 11 10 9 8 VDD T1 T3 T5 T7 T9 T10 N/C N/C DDU7C-xx DDU7C-xxA3 DDU7C-xxB3 DDU7F-xxMC3 DIP Gull-Wing J-Lead Military SMD Military DIP DDU7C-xxM FUNCTIONAL DESCRIPTION PIN DESCRIPTIONS The DDU7C-series device is a 10-tap digitally buffered delay line. The IN Signal Input signal input (IN) is reproduced at the outputs (T1-T10), shifted in time by an T1-T10 Tap Outputs amount determined by the device dash number. The nominal tap-to-tap VDD +5 Volts delay increment is given by 1/10 of the dash number. For dash numbers GND Ground less than 50, the total delay of the line is measured from T1 to T10, with the nominal value given by 9 times the increment. The inherent delay from IN to T1 is nominally 8.0ns. For dash numbers greater than or equal to 50, the total delay of the line is measured from IN to T10, with the nominal value given by the dash number. SERIES SPECIFICATIONS * * * * * * Minimum input pulse width: 20% of total delay Output rise time: 8ns typical Supply voltage: 5VDC 5% Supply current: ICCL = 40a typical ICCH = 10ma typical Operating temperature: 0 to 70 C Temp. coefficient of total delay: 300 PPM/C 3.5ns 10% 10% 10% 10% 10% 10% 10% 10% 10% DASH NUMBER SPEC.'S Part Number DDU7C-25 DDU7C-100 DDU7C-150 DDU7C-200 DDU7C-250 DDU7C-300 DDU7C-400 DDU7C-500 Total Delay (ns) 22.5 2.0 * 100 5.0 150 7.5 200 10.0 250 12.5 300 15.0 400 20.0 500 25.0 Delay Per Tap (ns) 2.5 1.0 10.0 2.0 15.0 2.0 20.0 2.0 25.0 2.0 30.0 3.0 40.0 4.0 50.0 5.0 * Total delay is referenced to first tap Input to first tap = 8.0ns 2ns NOTE: Any dash number between 25 and 500 not shown is also available. VCC IN T1 T2 T3 T4 T5 T6 T7 T8 T9 T10 GND Functional diagram for dash numbers < 50 10% 10% 10% 10% 10% 10% 10% 10% 10% 10% VCC IN T1 T2 T3 T4 T5 T6 T7 T8 T9 T10 GND Functional diagram for dash numbers >= 50 (c)1997 Data Delay Devices Doc #97019 1/30/97 DATA DELAY DEVICES, INC. 3 Mt. Prospect Ave. Clifton, NJ 07013 1 DDU7C APPLICATION NOTES HIGH FREQUENCY RESPONSE The DDU7C tolerances are guaranteed for input pulse widths and periods greater than those specified in the test conditions. Although the device will function properly for pulse widths as small as 20% of the total delay and periods as small as 40% of the total delay (for a symmetric input), the delays may deviate from their values at low frequency. However, for a given input condition, the deviation will be repeatable from pulse to pulse. Contact technical support at Data Delay Devices if your application requires device testing at a specific input condition. POWER SUPPLY BYPASSING The DDU7C relies on a stable power supply to produce repeatable delays within the stated tolerances. A 0.1uf capacitor from VDD to GND, located as close as possible to the VDD pin, is recommended. A wide VDD trace and a clean ground plane should be used. DEVICE SPECIFICATIONS TABLE 1: ABSOLUTE MAXIMUM RATINGS PARAMETER DC Supply Voltage Input Pin Voltage Storage Temperature Lead Temperature SYMBOL VCC VIN TSTRG TLEAD MIN -0.3 -0.3 -55 MAX 7.0 VDD+0.3 150 300 UNITS V V C C NOTES 10 sec TABLE 2: DC ELECTRICAL CHARACTERISTICS (0C to 70C, 4.75V to 5.25V) PARAMETER High Level Output Voltage Low Level Output Voltage High Level Output Current Low Level Output Current High Level Input Voltage Low Level Input Voltage Input Current SYMBOL VOH VOL IOH IOL VIH VIL IIH MIN 3.98 TYP 4.4 0.15 MAX UNITS V V mA mA V V A NOTES VDD = 5.0, IOH = MAX VIH = MIN, VIL = MAX VDD = 5.0, IOL = MAX VIH = MIN, VIL = MAX 0.26 -4.0 4.0 3.15 1.35 0.10 VDD = 5.0 Doc #97019 1/30/97 DATA DELAY DEVICES, INC. Tel: 973-773-2299 Fax: 973-773-9672 http://www.datadelay.com 2 DDU7C PACKAGE DIMENSIONS 16 15 14 13 12 11 10 9 Lead Material: Nickel-Iron alloy 42 TIN PLATE 14 13 12 11 10 1 2 3 4 5 6 7 8 9 8 .440 MAX. .280 MAX. .290 MAX. 1 2 3 4 5 6 7 .900 MAX. .830 MAX. .015 TYP. .010.002 .018 TYP. .070 MAX. .700.010 7 Equal spaces each .100.010 Non-Accumulative .350 MAX. .600 TYP. .030 .290 .005 MAX. .195 .010 .020 TYP. .010 TYP. .300 TYP. DDU7C-xx (Commercial DIP) DDU7C-xxM (Military DIP) .020 TYP. 16 15 14 13 12 11 10 9 .040 TYP. .270 TYP. .010 TYP. .020 TYP. 16 15 14 13 12 11 10 9 .040 TYP. .270 TYP. .050 TYP. .320 TYP. .430 TYP. 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 .110 .100 .600 .790 MAX. .300 MAX. .050 TYP. .110 .700 .890 MAX. .100 .350 MAX. .110 TYP. DDU7C-xxA3 (Commercial Gull-Wing) DDU7C-xxB3 (Commercial J-Lead) .020 TYP. 16 15 14 13 12 11 10 9 .040 TYP. .010.002 .710 .590 .005 MAX. .882 .005 .007 .005 1 2 3 4 5 6 7 8 .090 .700 .880.020 .100 .280 MAX. .050 .010 DDU7C-xxMC3 (Military Gull-Wing) Doc #97019 1/30/97 DATA DELAY DEVICES, INC. 3 Mt. Prospect Ave. Clifton, NJ 07013 3 DDU7C DELAY LINE AUTOMATED TESTING TEST CONDITIONS INPUT: Ambient Temperature: 25oC 3oC Supply Voltage (Vcc): 5.0V 0.1V Input Pulse: High = 5.0V 0.1V Low = 0.0V 0.1V Source Impedance: 50 Max. Rise/Fall Time: 5.0 ns Max. (measured between 0.5V and 4.5V ) Pulse Width: PWIN = 1.5 x Total Delay Period: PERIN = 10 x Total Delay OUTPUT: Load: Cload: Threshold: 1 FAST-TTL Gate 5pf 10% 2.5V (Rising & Falling) NOTE: The above conditions are for test only and do not in any way restrict the operation of the device. COMPUTER SYSTEM PRINTER T1 PULSE GENERATOR OUT TRIG DEVICE UNDER TEST (DUT) IN T2 T3 T4 T5 T6 T7 T8 T9 T10 REF IN TRIG TIME INTERVAL COUNTER Test Setup PERIN PWIN TRISE INPUT SIGNAL 4.5V 2.5V 0.5V TFALL VIH 4.5V 2.5V 0.5V VIL TFALL TRISE OUTPUT SIGNAL VOH 2.5V 2.5V VOL Timing Diagram For Testing Doc #97019 1/30/97 DATA DELAY DEVICES, INC. Tel: 973-773-2299 Fax: 973-773-9672 http://www.datadelay.com 4 |
Price & Availability of DDU7C-XXX |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |